Humi Controller 16 AMP

Humi controller on one side has a male plug which is connected to the electrical current, and on the front another female plug to which the humidifier or dehumidifier is connected according to the needs of the space where humidity is controlled.

The Humicontroller probe allows humidity to be measured and automatically powers the Humidifier or Dehumidifier. The probe cable is extendable up to 5 meters away, allowing its ideal location in the room to correctly measure humidity. Humicontroller is rated at 16 AMP.

Humi controller Instructions for Use

Select the ideal place in your growing space and place the probe (5m cable) and the controller to control the humidity

Depending on the needs to control the amount of humidity in the space, connect either a Humidifier or a Dehumidifier to the controller.

Once plugged into the digital screen, choose a mode of use and select the desired humidity. Automatically in Humidifier mode, the controller will activate the humidifier whenever it detects that it is lower than that specified above. And in Dehumidifier mode it will be activated when it detects that it is higher than desired.
On the left side the actual humidity of the space is displayed and on the right the configured humidity.

USE WARNINGS:

Avoid placing the controller in a location highly exposed to intense heat and humidity levels. Try, above all, not to place it next to a source of heat (stoves, spotlights), or moisture (humidifier).

NOTE: NEVER exceed the maximum allowable load (AC motors).